2-Pin Male-to-Male LED Strip Jumper Cable — 50cm Extension Lead, 10-Pack
Bridge gaps between LED strip segments, extend runs around obstacles, or connect your power supply to the first strip section with these pre-terminated 50cm jumper cables. Each cable features standard 2-pin male connectors on both ends, mating directly with our solderless connector ecosystem and most major-brand LED strip clips. The 22AWG copper conductors handle up to 5A continuous — more than enough for single-color strips up to 10 meters.
Build Quality That Shows in the Details
- 22AWG Stranded Copper Conductors — Flexible enough to route through tight conduit and around corners without kinking, yet thick enough to minimize voltage drop over the 50cm length. Measured resistance: less than 0.05 ohms per conductor.
- Polarized Male Connectors — Keyed housing prevents reverse-polarity connection, protecting your LED strip from accidental damage during installation. The positive pin is marked with a red stripe on the cable jacket for quick visual identification.
- Double-Insulated PVC Jacket — Rated for 300V working voltage with a flame-retardant PVC outer sheath (UL Style 1007). Safe to run alongside mains wiring in conduit and junction boxes.
- Strain Relief Boots — Molded PVC boots at each connector prevent wire pull-out when tension is applied during installation, a common failure point in economical jumper cables.
Technical Specifications
| Parameter | Value |
|---|---|
| Cable Length | 50cm (19.7 inches) |
| Connector Type | 2-Pin Male to 2-Pin Male |
| Wire Gauge | 22AWG (7/0.2mm stranded) |
| Max Current | 5A continuous |
| Max Voltage | 24V DC (300V insulation rating) |
| Conductor Material | Tinned copper, stranded |
| Jacket Material | PVC, UL Style 1007, flame retardant |
| Operating Temperature | -20C to +80C |
| Polarity Marking | Red stripe = positive |
| Quantity per Pack | 10 cables |
Common Use Cases
- Extending LED strip runs around kitchen cabinets, staircases, and architectural features
- Bridging gaps between strip segments where direct connection is not possible
- Connecting a DC power supply to the first LED strip segment in a run
- Creating service loops for LED strip installations that may need future maintenance access
BrightLink Quality
Manufactured in our ISO 9001 facility with 100% continuity and insulation testing. Each cable is individually inspected for connector alignment and crimp quality. Backed by a 2-year warranty. Compatible with all BrightLink solderless connectors and most third-party 8mm 2-pin LED strip systems.
Reviews
There are no reviews yet.