8mm 2-Pin Solderless LED Strip Connectors — 10-Pack, Tool-Free Installation
Eliminate soldering from your LED strip projects with these precision-machined 8mm 2-pin solderless connectors. Each pack contains 10 units, giving you enough hardware for a complete installation with spares. The spring-loaded clamp mechanism grips the copper pads on your LED strip firmly, creating a gas-tight connection that outperforms hand-soldered joints in both conductivity and long-term reliability.
Why Go Solderless?
- No Soldering Iron Required — Perfect for on-site installations where power tools are impractical. Simply strip the LED strip at the cut mark, lift the clamp, insert the PCB edge, and press down. Total connection time: under 10 seconds per joint.
- Consistent Connection Quality — Every connector applies the same spring pressure, eliminating the cold-solder joints and bridged pads that plague hand-soldered connections. Tested to carry 5A continuous with less than 20mV drop.
- Reusable & Reworkable — Unlike solder, these connectors can be opened and re-seated up to 50 times without degradation. Ideal for prototyping, rental installations, and seasonal decorations that get reconfigured annually.
- Ultra-Low Profile — At just 13mm long and 9mm wide, the connector slides behind most diffuser covers and aluminum profile end caps, maintaining a clean invisible installation.
Technical Specifications
| Parameter | Value |
|---|---|
| PCB Width Compatibility | 8mm (standard single-color strips) |
| Pin Configuration | 2-Pin (V+ / V-) |
| Max Current Rating | 5A per channel |
| Max Voltage | 24V DC |
| Contact Material | Phosphor bronze, tin-plated |
| Housing Material | PA66 nylon, UL94 V-0 flame rated |
| Dimensions (LxWxH) | 13 x 9 x 5.5 mm |
| Wire Gauge Range | 18-24 AWG stranded |
| Operating Temperature | -20C to +80C |
| Quantity per Pack | 10 pieces |
Compatible LED Strip Types
- Single-color SMD 3528, 2835, 5050, and COB strips with 8mm PCB width
- 12V and 24V constant-voltage strips with 2-pin cut marks
- Strips with copper pad spacing of 2mm at cut points
Installation Guide
Cut the LED strip at the designated scissors mark to expose clean copper pads. Open the connector lever, slide the strip PCB edge fully into the slot ensuring both pads align with the contact pins, then close the lever until it clicks. For wire-to-strip connections, strip 5mm of insulation from a 18-24 AWG wire, insert into the wire channel, and clamp. Gently tug the strip to confirm a secure grip before powering on.
BrightLink Quality Promise
Every batch undergoes 100% electrical testing for contact resistance and insulation resistance before packaging. These connectors are manufactured in our ISO 9001 facility using UL-listed materials. Backed by BrightLink’s standard 2-year warranty against manufacturing defects.
Reviews
There are no reviews yet.